Forum Discussion

Suhas_1994's avatar
Suhas_1994
Icon for New Contributor rankNew Contributor
4 years ago

Board Test System not working

Hello Team, I have a Intel Cyclone GX FPGA 10CX220YF780E5G board connected to the desktop. As per the documentation of this board, to check whether the board is working I need to open and check in ...
Zarquin's avatar
Zarquin
Icon for Occasional Contributor rankOccasional Contributor
4 years ago

Dear Intel Support Team,

I' coming up with the same problem on both Dev Kits:

OS is Windows 10 Pro 1803. Doubleclicking on the BoardTestSystem.exe the application even doesn't show up. No error message.
I installed the Kit Installation (EXE) for Windows from the pages linked above. Dev kit is connected via USB. USB driver is installed and working.
Ethernet is connected and working. Switches and jumpers are set to default position. Tried both: SW4.3 FACT to off(1) and to on(0): Same behaviour. Both boards are still in factory configuration.

Any ideas?

Best regards

Zarquin's avatar
Zarquin
Icon for Occasional Contributor rankOccasional Contributor
4 years ago

... Little step further: BoardTestSystem.exe still no reaction but with java -jar bts.jar the application shows up.

Next problem: When I try to configure the device, the message: failed to configure conf_done did not go high shows up.

Complete console output:

Any ideas how to solve this?