Forum Discussion

New Contributor

2 years ago

AVST Booting of Arria 10 SoC using parallel flash connected to MAX10

Dear Ma'am/Sir, In our design we are using Arria 10 SoC, also we have max10 FPGA. Can I boot the configuration file from the parallel flash which is connected to the MAX 10 FPGA to the Arria 10 ...

EBERLAZARE_I_Intel

Regular Contributor

2 years ago

Hi,

Do you have any further questions?

Sivakumar_S
New Contributor
2 years ago
Hi,
First of thanks for the reply.
I have one more doubt for FPP mode also, can we use MAX10 for reading from parallel falsh and configuring the Arria 10SoC.

Wherever I am searching I am getting only Max v or max 2 series.

Here in this link also at last (MAX Series Configuration Controller Using Flash Memory white paper ) they have not mentioned Max10
https://www.intel.in/content/www/in/en/support/programmable/support-resources/configuration/cfg-fpp.html

So can we use max10 FPGA for FPP configuration.

Forum Discussion

AVST Booting of Arria 10 SoC using parallel flash connected to MAX10

Recent Discussions

Stratix 10 Development Kit HiLo connector

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

About PCIe Daughter Cards for Agilex™ 3 FPGA and SoC C‑Series Development Kit

DE10-Lite unable to flash?

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).