Forum Discussion
IanD
New Contributor
New ContributorArria 10 hold violations
Hello,
Using an Arria 10 board. Setup timing is clean, but I'm getting a few hold violations from the Arria PHY to an input FIFO. Clocks are correct and the violation only shows up sometimes. I.E -...
IanDNew Contributor
New ContributorThanks Richard. This only happens sometimes. The problem flop-flop paths have plenty of setup, but other paths on the same clock are just meeting setup.
I do have the "Optimize Hold timing" set, but I would like to try the seed sweep when I next see the problem. I don't see this option in version 21.3. Where can I find it?
