Most RecentWhy do I see Support-Logic Generation error when implementing the F-Tile Ethernet Intel® FPGA Hard IP with '50GE-2', 'MII PCS only' and 'None" FEC mode options selected ?Half Duplex Operation on 10/100M Ethernet MAC Not SupportedError: (vsim-3058) The width (1) of Verilog port 'scaninb' does not match the array length (8) of its VHDL connectionWhy do I get the error “Error (176286): Found 2 SPI blocks in design” when using Serial Flash Loader Intel® FPGA IP and ASMI Parallel II Intel FPGA IP?Why does the Multi Channel DMA IP for PCI Express* for P-Tile, have incorrect bus width for the Config TL Interface?Incorrect IP Functional Simulation Model for QDR II and QDR II SRAM Controller with UniPHYHow can I start SOPC Builder in Quartus II 7.2 (and later) in the "classic" GUI?Unable to load all the programming files specified in //network_path/filename.cofError: SERDES receiver node - Due to a problem in the Quartus® II software version 12.1 and later, you may see this error in Stratix® V devices when using the ALTLVDS_RX megafunction in external PLL mode.Internal Error: Sub-system: PE, File: /quartus/power/pe/pe.cpp, Line: 1351
