Open Side Menu
Skip to contentAltera Community
Forums
BlogKnowledge BaseAltera.com
RegisterSign In
  1. Altera Community
  2. Knowledge Base
  3. All Articles
  • WanGee's avatar

    Can the F-Tile FGT PMA lane in neutral state of Dynamic Reconfiguration be preserved?

    WanGee
    2 months ago
    108Views
    0likes
    0Comments
  • WanGee's avatar

    Why does the Quartus® Prime Pro Edition Software report that no IOPLL is available when placing the Low Latency E-Tile 40G Ethernet FPGA IP in an HPS shared GPIO Bank?

    WanGee
    2 months ago
    96Views
    0likes
    0Comments
  • WanGee's avatar

    Why does the dynamic reconfiguration simulation of Phylite IP design fail in the Questa* – Altera® FPGA Edition ?

    WanGee
    2 months ago
    117Views
    0likes
    0Comments
  • WanGee's avatar

    Design Assistant CDC-50001, CDC-50011, and CDC-50012 warnings from the F-Tile Dynamic Reconfiguration one-hot profile select paths

    WanGee
    2 months ago
    54Views
    0likes
    0Comments
  • WanGee's avatar

    Why does the Quartus® Prime Pro fitter fail when compiling the Agilex® 5 GTS HDMI IP Clocked Video design example with the HDMI PHY?

    WanGee
    2 months ago
    60Views
    0likes
    0Comments
  • WanGee's avatar

    Why is the LPDDR5 option unavailable in the External Memory Interfaces for HPS IP in Quartus® Prime Pro Edition Software version 26.1.1 for Agilex® 3 SoC FPGA?

    WanGee
    2 months ago
    234Views
    0likes
    0Comments
  • WanGee's avatar

    Does the TOD_MASTER_156_25MHz_P signal on the Agilex® 7 FPGA M-Series require external bias circuitry when AC-coupled?

    WanGee
    2 months ago
    51Views
    0likes
    0Comments
  • WanGee's avatar

    Why does the Agilex® 7 FPGA M-Series Development Kit fail configuration with bitstream error 0x0015?

    WanGee
    2 months ago
    52Views
    0likes
    0Comments
  • WanGee's avatar

    Why are Board Test System (BTS) power monitoring readings missing or inaccurate on the Agilex® 5 FPGA E-Series 065B Premium Development Kit?

    WanGee
    2 months ago
    57Views
    0likes
    0Comments
  • WanGee's avatar

    Why does the Quartus® Prime Programmer GUI fail JIC programming with "Different TAPS selected" or "Operation failed" in AS mode for device AGIB027R31B1E1VAA?

    WanGee
    2 months ago
    69Views
    0likes
    0Comments
Go to first page
Contact Us
Altera YoutubeAltera YoutubeAltera Twitter
  • Company Overview
  • Newsroom
  • Our Leaders
  • Careers
Subscribe to Altera Newsletter

© Altera Corporation | Terms of Use | Privacy Policy | Cookies | Trademarks | PSIRT

Altera Logo