Most RecentHang system when access to BAR0, SV HARD IP CORE AVMM DMAPLL warning about clkin pin locationHelp required! Baremetal application with custom PreloaderPossible cross-talk noise when using Tranceiver ToolkitCyclone10 do not support AS config scheme when Configurationn Voltage Standard=2.5V ?I'd lile to know the procedure in programming CFM memory area on EPM240xx devices.I write DFh to address 0 on "EPM240T100C5N" by the programmer, security is imposed on the CFM area and only 00 can be read. Is it possible to explain why security is applied even though Security bit is not set ?I wish to know the programming solutions of ALTERA EPM5128 chip, I like to read contents from master and then program other chipsI have a question on a FPGA P/N EP1C20F324C7 I want the signal DATADIR to go to gnd. Do I connect it directly to ground or do I Contact it to ground through a resister, and if I use a resistor what value should it be?EPCS16 Substitute
