Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

SignalTap II problem adding nodes

I've watched the training video, and it looks like the simplest way to tap into a node when using SignalTap is to open the Technology Map Viewer (Post Fitting), find the net, right click it and use t...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

For post-fit signaltap, you should pretty much only use register names. Combinatorially net names don't make much sense. If doing pre-synthesis, then you can use about anything, as synthesis will make sure the point you've tapped is the output of a cell. (I know I'm not helping with your original question...)