Forum Discussion

JPark222's avatar
JPark222
Icon for New Contributor rankNew Contributor
6 years ago
Solved

Signal Tap II error (261009)

The sof file is programmed/configured successfully, but Signal Tap complains with rather a ridiculous error: (I followed up the guide - create/modify stp by GUI, save/recompile) Error(261009): Cann...
  • JPark222's avatar
    JPark222
    6 years ago

    Sorry I didn't update sooner.

    The issue has been resolved by lowering JTAG frequency (default 24M to 6MHz) due to a rather long JTAG cable/connection. What confused me most was the success (or maybe "silent failure") of downloading sof at the default frequency.

sstrell's avatar
sstrell
Icon for Super Contributor rankSuper Contributor
6 years ago

It's not a JTAG issue necessarily. Your .stp file is not matching the Signal Tap settings that have been programmed in the device. Check your project settings and make sure the correct .stp file is being pointed to. Save your .stp file and recompile. Try programming the device with the new programming file directly from the .stp file (upper right corner of the file).

#iwork4intel

Raphy's avatar
Raphy
Icon for New Contributor rankNew Contributor
4 years ago

thank you ,but I aware all this .

I only change the signals in the signal tap. nothing in the project.

Regards Raphy