Forum Discussion

VCham's avatar
VCham
Icon for Occasional Contributor rankOccasional Contributor
4 years ago

Modifying TimeQuest Temperature Parameter

Hello, I am developing firmware for a Cyclone V FPGA. Is it possible to modify the TimeQuest analyzer to run the slow and fast corner testing at temperatures other than 100C and -40C? We're hoping ...
VCham's avatar
VCham
Icon for Occasional Contributor rankOccasional Contributor
4 years ago

I didn't save the error, but during the fitter stage it said something along the lines of "invalid for selected device"

However, I did notice that there was an option under Operating Settings and Conditions to change the temperature min/max to different values. Not the ones I had manually written but closer. So perhaps there are preset options that are dependent on the device. This did result in the Timing Analyzer running the corner studies at the new values.