Have to support ancient product with EPM7032 CPLD <-> USB Blaster problems

Sorry for the mix-up. Yesterday I was accidentally running SignalTap. Today I'm running the programmer.

If I click Auto Detect, it comes up with UNKNOWN_F3E3F0DD as the detected device.

I can add the .pof file - device shows as EPM7032ST44, 60DC9 checksum, 0000FFFF usercode. An EPM7032 is indeed what is on the PCB.

If I click only the Program/Configure box for the .pof file and click Start, these are the messages I get:

Started Programmer operation at.....

Unrecognized device

JTAG ID code specified in JEDEC STAPL Format File does not match any valid JTAG ID codes for device

Operation failed

Ended Programmer operation at.....

The bottom window shows the TDI line going into the UNKNOWN_F3EFF0DD device, then out of that and into the EPM7032ST44, and the TDO line out from that and back to the programmer.

I can delete the unknown device and attempt to program again but with the same result.

[Hi FvM - know you from the CCS forum]