Forum Discussion

HBhat2's avatar
HBhat2
Icon for Contributor rankContributor
5 years ago

RX IDLE detect & Receiver Detect in Stratix 10 & Arria 10 Transceivers

Hi, I am working on PCS development for a custom protocol. 1)There is some condition to detect the RX presence. Here, the Transmitter side must detect that the receiver connected @ the RX side or...
CheepinC_altera's avatar
CheepinC_altera
Icon for Regular Contributor rankRegular Contributor
5 years ago

Hi HPB,


1. Receiver detection

[CP] As I understand, this feature is built in for the PIPE PHY but not normal Native PHY. I have no visibility into the circuitry or logic for the receiver detection and thus could not provide further comment on this. Sorry for the inconvenience.


2. Signal detection

[CP] In Native PHY, you can enable rx_signal_detect port and 8b10b for the signal detection.


Please let me know if there is any concern. Thank you.


Best regards,

Chee Pin