Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

Unable to configure a slave Stratix in PS mode from an EPCS64

I have a system consisting of a Cyclone IV GX and a Stratix of the first generation (EP1S25B672C6). The configuration device as an EPCS64. The GX is the master of the configuration chain, with the MS...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

1.Did you configure the Master as Active serial and select the configuration device?

2.Did you configure the slave as passive serial ?

If not, you could do it in the assignments -->device -->device and pin options-->configuration

3.Also check the does the DCLK and data goes to the slave device?

--Uday