Forum Discussion

EEren's avatar
EEren
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

SignalTap problem.

FPGA (MAX10) connected to a microcontroller board. If I disconnect the board SignalTap runs good. If I connect the board back - SignalTap starts and immediately writes - Invalid JTAG configuration. ...
ShafiqY_Intel's avatar
ShafiqY_Intel
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

Hi EEren,

Can you try jtagconfig command when Max 10 connected to microcontroller board?

(open Command Prompt ---> go to Quartus directory <Quartus installation directory>intelFPGA\18.1\quartus\bin64> ---> run jtagconfig)

Please send me he screenshot of the result.

Thanks