Forum Discussion
richwright
New Contributor
New ContributorRd, OCT Default Value in LVDS
I am using an Arria 10 GX device. There are a number of pins using LVDS IO standard. The Termination has been set in Pin Planner to Differential but the "Receiver On Chip Termination" has not been s...
Hi there
By checking on https://www.intel.com/content/www/us/en/programmable/documentation/sam1403483633377.html#sam1403482197912
The Rd OCT shall be of 100 ohm.
richwrightNew Contributor
New ContributorThank you very much for this response. Can you tell me about the default termination value if the INPUT_TERMINATION is set to DIFFERENTIAL in Assignment editor but no termination value is specified by the designer?
EngWei_O_Intel
Frequent Contributor
Frequent ContributorHi there
By checking on https://www.intel.com/content/www/us/en/programmable/documentation/sam1403483633377.html#sam1403482197912
The Rd OCT shall be of 100 ohm.
