Forum Discussion
Altera_Forum
Honored Contributor
Honored Contributorpin assignment problem
Hi, I am new to quartus ii. I have created a bdf file instead of verilog/vhdl . i am taking input through terasic data conversion card and through sma cable i am giving a sine wave but i am not...
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- when i see the pin planner there is no location , bank and pin assigned to inputs and outputs --- Quote End --- There will be at least an automatically selected fitter location shown for each port signal after compilation if you didn't assign a location. Did you select a FPGA type in device assignments? --- Quote Start --- I have imported the pin assignments --- Quote End --- How?
