Altera_ForumHonored Contributor17 years agoOutput IO Buff is too large; DDR3 Hello, I downloaded and ran the altdq_dqs example from Altera literature webside. The example claimed these IO BUFFs could handle up to 333.333 MHz (3ns), but I found that their output B...Show More
Altera_ForumHonored Contributor17 years agoThe interface of my project is different than the ALTMEMPHY. So I cannot use this ALTMEMPHY.
Recent DiscussionsRegarding Power-Up Sequence for Agilex 5Cyclone V SoC 5CSXC6 Series GXB Utilization and LimitationsHow to tell Quartus my Arria10 target system CLKUSR frequency is 100MHz?Agilex 3 PLL in Source Synchronous mode ?writing a word to cfm1 using on chip flash ip on max10