Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

FPGA fried?

Hi, I am using a cyclone iii on a custom board I made and I am trying to make sure the fpga section of the board is functional. When I program the fpga, I get the "100% successful" message from...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

Thanks gj_leeson.

You were right, it was the "Config_done" pin. It was pulled up to 1.2V with a 1Kohm. I changed it to a 10K to 2.5V and now it's working.

You guys were great help.