Forum Discussion

ALee11's avatar
ALee11
Icon for New Contributor rankNew Contributor
7 years ago

EMIF TOOLKIT failure, see screenshot. Added Hard Memory controller to design, but calibration results show a failure in the EMIF toolkit. what is the source of the error?

we integrate a HMC (Hard Memory Controllers) in our design. Each such HMC is connected to 40bit DDR3 bus where 32bits used as data and additional 8 bits used for ECC. We try to check the calibration ...
ALee11's avatar
ALee11
Icon for New Contributor rankNew Contributor
7 years ago

is cyclone V "E" supported in the tool at all? Is the restriction just on Cyclone V SOC or Cyclone V SOC AND Cyclone V E as stated in the link in my original post?

  • NurAida_A_Intel's avatar
    NurAida_A_Intel
    Icon for Frequent Contributor rankFrequent Contributor
    7 years ago

    Hi ALee11,

    Sorry I overlook your question. Yes, Cyclone V E is supported in the tool. The restriction only for Cyclone V SoC part.

    Thanks

    Regards,

    NAli1