cyclone V GX FPGA board starter kit

Question

i have a program have 5 i/p (clk, reset, sw1, sw2, sw3) and 8 o/p  (LED1, LED2, LED3, LED4, LED5, LED6, LED7, LED8), after i successfully downloaded to the cyclone V GX FPGA board starter kit. the results on the output LEDs is not correct, while when i implement the same program on another type of altera FPGA board the correct results is produced. why?? what about this problem in cyclone V GX FPGA board starter kit?

altera_forum · Answer

Thousands of reasons... Debug your design using SignalTap.

altera_forum · Answer

I put some files on the altera wiki a few weeks ago that may help you to understand the Cyclone 5 starter kit, its' HDMI Output & an mSGDMA controller, not the old SGDMA controller.

http://www.alterawiki.com/wiki/cyclone5_starterkit_hdmi

Forum Discussion

cyclone V GX FPGA board starter kit

2 Replies

Recent Discussions

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

System PLL of Agliex5 PCIE example design cannot be locked after configuration

JTAG Chain Broken on Agilex 7-I Dev Kit

Request for Cyclone V Pinout File Information

Cyclone 10 LP's Extended Industrial parts