Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

Cyclone III not configuring, using AS.

I'm currently using Cyclone III (EP3C5F256C8) and I'm trying to configure it and it's not happening. I'm using AS connected to a FLASH chip (M25P16). nCONFIG, nSTATUS, CONF_DONE and INIT_DONE are pul...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

Do you see any activity on nSTATUS - other than when it 'follows' nCONFIG at the start of a configuration cycle? This would indicate an error in the data the FPGA is receiving.

Cheers,

Alex