SK_VA
Occasional Contributor
Occasional ContributorCtrl + C in NIOS shell
When I try to break a process by pressing Ctrl + C in NIOS shell. The process does not stop. Is there any settings to be done to accept Ctrl +C command in NIOS shell.
Forum Discussion
Ahmed_H_Intel1
Frequent Contributor
Frequent ContributorHi SANJU ALIAS,
The Ctrl+c used to terminate your GDB debugger session. No extra setting to be set for this command.
Please check the useful link below:
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/nios2/edh_ed51004.pdf
Regards,
