CPLD programming using embedded microprocessor

Question

I wish to program MAX V CPLD usind an embedded microprocesssor.For so,I have assigned four GPIO pin of my processor as JTAG signalling pins TCK,TDI,TDO,TMS.How can these 4 pins be used to program CPLD?

altera_forum · Answer

Ref:   https://www.altera.com/support/support-resources/support-centers/devices/programming-tools/jam-stapl/tls-jam-embedded.html

Forum Discussion

CPLD programming using embedded microprocessor

1 Reply

Recent Discussions

FPGA issue on electronic board

Agilex 7 Decoupling capacitor scaling factor

Does the Post-Configuration BSDL Generator for Cyclone 10 LP require an NDA?

carry chain tdc

Issue with configuring EPCQ64A & Cyclone10LP using NiosV as processor.