Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorCan't upload program to DEO Nano
Hi guys, I'm newbie in FPGA. Recently, i learn how to control the dc motor and read some sensor use DEO Nano. Until last night my DEO Nano Board was doing well. But suddenly, i can't upload...
Altera_ForumHonored Contributor
Honored Contributorhi,
Error: Can't access JTAG chain error means your JTAG chain is not up. One of the possibility would be your USB blaster driver is not detected. Go to your Device Manager driver section to check if the USB blaster driver is detected correctly. TDI and TDO on the JTAG chain must be a close-loop, otherwise, you will get this error. You can follow this link for JTAG issue debugging. Hope this help. http://www.altera.com/cgi-bin/ts.pl?fn=jtagprog&hi=2-8Hope this help. . . idhhoiewojr;owej;ojsd;kfnksdnhr;oirjhfoi;we
