Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

blinking of two LED's.

Hello, Hi guys. i wrote a program in verilog of updown counter. As the board I am using is of 50 Mhz, so to actually see the LED blinking I divided the clock. My output was routed to single...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

Are you sure about the polarity of the reset signal? Is it coming from an FPGA pin? It could be an active low signal.