Forum Discussion
DavidAz
New Contributor
New ContributorArria 10 VCCR_GXB when not using transceivers
We are using an Arria 10GX but not using the transceivers. According to the documentation we still need to power a few VCCR_GXB pins for proper operation of the FPGA. Since we are not using the tra...
EngWei_O_Intel
Frequent Contributor
Frequent ContributorHi there
We need to make sure those pins listed in the banks below is powered on to its operation level:
The allowable range mentioned in datasheet is 0.92 - 0.98V.
