Anyone here using DE2 Terasic board??

I am using terasic DE1 board, and I am trying to add a text LCD like you have built into the DE2. Can anyone give me any extra notes, comments or things to watch out for if I use this code from the DE2 starter kit? Any help would be much appreciated, I am working by myself at home. I especially need helping figuring out what to set for istart and oDone signals. And will I save time including the code for "LCD_TEST" or just send this module the same bytes LCD_TEST did.

I understand we do this for fun on your own time. I really appreciate any notes or advice on this.

module LCD_Controller ( // Host Side

iDATA,iRS,

iStart,oDone,

iCLK,iRST_N,

// LCD Interface

LCD_DATA,

LCD_RW,

LCD_EN,

LCD_RS );

// CLK

parameter CLK_Divide = 16;

// Host Side

input [7:0] iDATA;

input iRS,iStart;

input iCLK,iRST_N;

output reg oDone;

// LCD Interface

output [7:0] LCD_DATA;

output reg LCD_EN;

output LCD_RW;

output LCD_RS;

// Internal Register

reg [4:0] Cont;

reg [1:0] ST;

reg preStart,mStart;

/////////////////////////////////////////////

// Only write to LCD, bypass iRS to LCD_RS

assign LCD_DATA = iDATA;

assign LCD_RW = 1'b0;

assign LCD_RS = iRS;

/////////////////////////////////////////////

always@(posedge iCLK or negedge iRST_N)

begin

if(!iRST_N)

begin

oDone <= 1'b0;

LCD_EN <= 1'b0;

preStart<= 1'b0;

mStart <= 1'b0;

Cont <= 0;

ST <= 0;

end

else

begin

////// Input Start Detect ///////

preStart<= iStart;

if({preStart,iStart}==2'b01)

begin

mStart <= 1'b1;

oDone <= 1'b0;

end

//////////////////////////////////

if(mStart)

begin

case(ST)

0: ST <= 1; // Wait Setup

1: begin

LCD_EN <= 1'b1;

ST <= 2;

end

2: begin

if(Cont<CLK_Divide)

Cont <= Cont+1;

else

ST <= 3;

end

3: begin

LCD_EN <= 1'b0;

mStart <= 1'b0;

oDone <= 1'b1;

Cont <= 0;

ST <= 0;

end

endcase

end

end

end

endmodule