Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

10m02sce144

My component '10M02SCE144and I can not program the pin relative to the PLL as a normal I / O (pin 25/26/27/28/32/33).How can I move into the output pin 32.Any suggestion and 'welcome
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

OK. I try to read through pin 32 (as shown) of my device 10M02SCE144 the logic associated with the input port status 0/1 INPUT8, nothing special except that the logic level of this input is with pull-shot up to 2V while the others are at 3V3. At this point by setting the logic signal to 0 or 3v3 I do not get input variations. Other pins of the same component work correctly, those related to the PLL I can not make them work as a simple I / 0, as if they were associated with another.I also replaced the component thinking it was dead, but I get the same defect.I do not understand where I'm wrong