Forum Discussion

New Contributor

5 years ago

Why got Error when try to upgrade QSYS from Standard 18.1 to 19.1. some of "module not found ".

I have design for MAX10 include Qsys with Nios running on Quartus 18.1 . I try to run on Quartus 19.1 and upgrade all IPs. the upgrading successful but failed when try to Generate RTL . the Error ...

SyafieqS

Super Contributor

5 years ago

Hi Amar,

Try to upgrade the IP one by one instead of upgrading all at a time. Refer to link below for details. Then regenerated the hdl again. Below are few links that might be helpful for your reference.

https://www.intel.com/content/www/us/en/programmable/quartushelp/17.0/hdl/mega/mega_upgrade_ip.htm

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-qpp-platform-designer.pdf (p58)

Thanks,

Regards

Forum Discussion

Why got Error when try to upgrade QSYS from Standard 18.1 to 19.1. some of "module not found ".

Recent Discussions

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Mandelbrot viewer on Cyclone V - Platform Designer layout

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

Stratix 10 Development Kit HiLo connector