What is the overshoot and undershoot values for the LVDS logic of 2.5V

Question

In my design i am using the cyclone 3 device with the manufacturer part number "EP3C55F484I7NGA". I was doing SI simulations for the 2.5V nets. In the device datasheet they have not given the electrical specification of the maximum overshoot and undershoot values.

Kindly provide, what can be considered as overshoot and undershoot for 2.5V LVDS logic.

yuanli_s_intel · Answer

Why not? Please refer to link below:https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyc3/cyc3_ciii52001.pdf (Page 2)

yuanli_s_intel · Answer

Overshoot and undershoot is not depending on the I/O Standard. Is actually depending on the I/O buffer. Thus, you may refer to the link as stated above. For LVDS, what you need to consider is the VICM and VID.

Regards,

YL

Forum Discussion

What is the overshoot and undershoot values for the LVDS logic of 2.5V

2 Replies

Recent Discussions

DE10-Lite unable to flash?

Stratix 10 Development Kit HiLo connector

Stratix 10 GX development kit BTS SW download

A question about reading the configuration space of the R-Tile PCIe IP EP

DE1-SoC project compiles, but board programming fails 42%. Other programs work fine