Forum Discussion

MFogl's avatar
MFogl
Icon for New Contributor rankNew Contributor
7 years ago

Using ADC feature and JTAG @ 3.3V

Dear Sirs, I have a project using a Max 10 device (10M08DAF256) and I wish to use the ADC feature and I have the JTAG interface at 3.3V (the Max device will be in a programming chain), so the VCCIO1...
Rahul_S_Intel1's avatar
Rahul_S_Intel1
Icon for Frequent Contributor rankFrequent Contributor
7 years ago

Hi Macro,

The below is for line page no:14

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/dp/max-10/pcg-01018.pdf

If you enable the ADC feature, connect

VCCIO1A and VCCIO1B to 2.5-V.

>>Yes

The VCCIO1B have to be power up with 2.5V if ADC is been enabled and JTAG pin have to supply have to be with compactable supply.

Regards,

Rs

Page no: 21 onwards use cases are shown

b) If you enable the ADC feature, connect

VCCIO1A and VCCIO1B to 2.5-V.

and