Forum Discussion

YKaji1's avatar
YKaji1
Icon for New Contributor rankNew Contributor
6 years ago

Red leds of Arria 10 dev board illuminate

I am using arria10 dev board. After I programmed a flash file to the device via Ethernet, red leds (D3-D10) illuminated after power on the device. Even if factory mode is on, red leds illuminate....
YKaji1's avatar
YKaji1
Icon for New Contributor rankNew Contributor
6 years ago

Hi

I am using A10 GX.

After posting this question, I fixed the problem by reading below thread.

https://forums.intel.com/s/question/0D50P00003yyTZQSA2/arria-10-gx-fpga-dev-kit-examples-jtag-id-code-issue

I changed a QUARTUS_ROOTDIR environment vairable for Quartus 17.1.

After rebooting the PC, after that jtag error was not shown and I could do factory reset.

The flash file was also something wrong.

Because after uploading a flash file, "Factory Restore for MAX 10 Dev Kits" page was displayed.

I remade a flash file and uploaded it to A10 GX dev board.

This works fine.

Thank you for your concern.