QSPI in the MAX 10 FPGA

Question

I'm just starting with FPGA development.

In a MAX 10 family FPGA, can I have a QSPI communication to receive data in time to perform a power switch modulation and also use this same communication channel to remotely update the Firmware of this FPGA?

Thank you and sorry for any confusion.

Att,

yuanli_s_intel · Answer

To interact with QSPI, you may use serial flash IP for that. Check out the user guide at link below:https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-gen-sfi.pdf

Forum Discussion

QSPI in the MAX 10 FPGA

1 Reply

Recent Discussions

MAX10 10M50 Development KIT Triple Speed Ethernet problem

About PCIe Daughter Cards for Agilex™ 3 FPGA and SoC C‑Series Development Kit

Stratix 10 FPGA Dev Kit VCCIO_FMC voltage issue

Stratix 10 Development Kit HiLo connector

Technical Assistance Request for Stratix® 10 SX SoC Development Kit (so#488775)