Forum Discussion

JGeor12's avatar
JGeor12
Icon for New Contributor rankNew Contributor
6 years ago

I am working with the cyclone V device.Currently i am processing the lvds signals.

The major problem is, i cannot route the input lvds signal between the input to the LVDS_RX IP and input to the lcd externally connected at the same time.Either as input to the lcd or IP is possible....
SreekumarR_G_Intel's avatar
SreekumarR_G_Intel
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

i am really not getting your questions , Kindly attach the design and error message ..i will work on it and try to give the soultion if i can.

Thanks

  • JGeor12's avatar
    JGeor12
    Icon for New Contributor rankNew Contributor
    6 years ago

    I am connecting the LVDS output from a board A1 to the custom board with FPGA 5CEBA2F23C8. This is then transmitted to HDMI interface. I also need to loopback the LVDS data coming to the custom board to an LCD. But while compiling in Quartus some errors are occuring in 'Fitter( (Place and Route)'

    The following are the error messages:

    Error (170143): Final fitting attempt was unsuccessful

    Info (170138): Failed to route the following 6 signal(s)

    Info (170139): Signal "lvdse_in[0]~input"

    Info (170139): Signal "lvdse_in[4]~input"

    Info (170139): Signal "lvdse_in[1]~input"

    Info (170139): Signal "lvdse_in[5]~input"

    Info (170139): Signal "lvdse_in[2]~input"

    Info (170139): Signal "lvdse_in[6]~input"