Forum Discussion
JGeor12
New Contributor
New ContributorI am working with the cyclone V device.Currently i am processing the lvds signals.
The major problem is, i cannot route the input lvds signal between the input to the LVDS_RX IP and input to the lcd externally connected at the same time.Either as input to the lcd or IP is possible....
SreekumarR_G_Intel
Frequent Contributor
Frequent ContributorI am not getting your question ; You were saying you are not able to connect the output of the LVDS IP to your LCD ?
Would it possible to share the deisgn to check quickly ?
Thank you ,
Regards,
Sree
JGeor12New Contributor
New ContributorThe output of ip is not connected to the lcd. The input of this lcd is lvds signals.So here the problems is , i can't give lvds signals as input to RX ip and LCD at the same time.only one is possible.
