Forum Discussion

New Contributor

5 years ago

How to turn off SRAM programming in MAX 10 JBC player ?

We are using MAX 10 device (10M25DCF256). We have implemented the JBC player in our embedded processor to program the internal flash of the FPGA via JTAG. During this process, there is a debug messag...

YuanLi_S_Intel

Regular Contributor

5 years ago

Hi Tim,

Apologize it cannot be. It is part of the process to program it. However, you can adjust the delay based on the processor speed. You may refer to user guide below for more information:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an586.pdf (Page 5)

Thank You

Forum Discussion

How to turn off SRAM programming in MAX 10 JBC player ?

Recent Discussions

Mandelbrot viewer on Cyclone V - Platform Designer layout

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

Stratix 10 Development Kit HiLo connector