How can I change REFCLK_EMIF frequency on Cyclone 10 GX Development Kit?

Question

Hello,My problem is to change REFCLK_EMIF frequency coming from Si5332 to 50 or 100 MHz. So far I can see only one option to re-program Si5332 via I2C from MAX10. But it too complicated and is going to take a while.Is there any other quicker option?

nuraida_a_intel · Accepted Answer

Dear MEmel1,Thank you for joining this Intel Community.You can use the clock controller GUI available in Cyclone 10 Dev Kit website to change the Si5332 frequency.You may refer to this dev kit user guide on page 57 for more details:https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-c10-gx-fpga-devl-kit.pdfAlso attached is some guideline steps to configure the Si5332 clock generator. Hope this is helpful. ThanksRegards,NAli1

Forum Discussion

How can I change REFCLK_EMIF frequency on Cyclone 10 GX Development Kit?

2 Replies

Recent Discussions

Device stopped receiving config data: Internal error (0x0000, 0x00000000, 0x1800).

Mandelbrot viewer on Cyclone V - Platform Designer layout

Slow Runtime Performance in FIL Implementation on DE2-115 Using Ethernet

Stratix 10 GX SI Board - issue with the Board Test System (BTS)

Stratix 10 Development Kit HiLo connector