Forum Discussion

LGonz14's avatar
LGonz14
Icon for New Contributor rankNew Contributor
7 years ago

has anyone had issues programming Cyclone 10 GX FPGA using Cyclone 10 GX FPGA Development Kit?

I'm currently working with the Cyclone 10 GX Dev kit for a development project and I'm having issues with the JTAG chain ​after programming the FPGA in Active Serial mode. The JTAG chain is broken af...
LGonz14's avatar
LGonz14
Icon for New Contributor rankNew Contributor
7 years ago
Hi MShafiq, Unfortunately, setting the TCK frequency to 6Mhz doesn’t make a difference because the programmer gives me the following error message: Error(209040): Can't access JTAG chain Regards, Luis A. Gonzalez R&D Department Staff Sr. Electrical Engineer (DSP/FPGA) Beckman & Coulter, Inc. 11800 SW 147th Ave Miami, FL 33196 Tel: (305) 380-3787 [cid:[email protected]]