Forum Discussion

RFett's avatar
RFett
Icon for New Contributor rankNew Contributor
6 years ago

Error on attempt to download sof and jic file to Cyclon 10GX dev. board using JTAG. How to proper setup to get jic file programmed to EPCQL1024?

Using the C10 CVP sample project I added the Serial Flash Loader IP to the design into the top_hw.v. I setup the jtag chain for the Cyclon 10 GX Dev. Kit, download the 10 design (sof) -> ok and down...
RFett's avatar
RFett
Icon for New Contributor rankNew Contributor
6 years ago

Hello John

I was able to download the jic to the device. Thank you for this.

Correct me if I am wrong: if I includ the flash loader ip into my design, after power up the programmer should recognize the epcql1024 when scanning the chain?

Thank you!

Roland