Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

DE0-CV programming error

I am using the DE0_CV_PS2_DEMO project from Terasic. I try to program the device and I get: Info (209060): Started Programmer operation at Sat Oct 07 07:59:38 2017 Error (209015): Can't configu...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Hi yileku,

Check the correct physical Cyclone V part number on your board. Make sure the Quartus project design is set to targeted to the correct Cyclone V part number. Then recompile your project design to the correct .sof file.

Regards,

nyusof

(This message was posted on behalf of Intel Corporation)