Forum Discussion

yanzhaopeng's avatar
yanzhaopeng
Icon for New Contributor rankNew Contributor
5 years ago

Cyclone V - JTAG ID Error

Hi, I designed a circuit board using 5CSEBA5U23I7,encountered some problems: 1:In the Programmer,when I clicked on "Auto Detect", I cannot get the correct JTAG ID as shown in the picture. 2:When...
YuanLi_S_Intel's avatar
YuanLi_S_Intel
Icon for Regular Contributor rankRegular Contributor
5 years ago

Hi,


Just would like to check, have you installed cyclone V during Quartus installation? When you mention about heat up, is happening when it is connecting to JTAG chain before doing device configuration?


Thank You.


  • yanzhaopeng's avatar
    yanzhaopeng
    Icon for New Contributor rankNew Contributor
    5 years ago

    Hi, YuanLi S

    Thanks very much for your reply.

    I have installed cyclone V during Quartus installation.

    Heat up as soon as power is on.

    Thank you.