Forum Discussion
Occasional ContributorIntel BD-NVV-N3000-2 issue
Occasional ContributorHi Jonway,
LED is blinking 1sec.
Aux power cable is connected to FPGA card which was delivered with Intel server.
Server is installed in datacenter and there is sufficient cooling.
Frequent ContributorWhen the FPGA Die Temperature hits 100C, it will shutdown the card. I believe the card does not shutdown instantly upon power up, you may take awhile for the card to heat up. While it is still operational, run "watch -d -n 1 fpgainfo bmc"...monitor the card...if the FPGA Die temperature goes into the 90-100C range - you do not have enough cooling.
- samir_bhansali
Hi Jonway,
Can you please share the link to download the below tool/package?
Looks command is not available.
O/P:-
------------------------
sh: fpgainfo: command not found
-----------------------
- JonWay_altera
You will need to install the Acceleration Stack (Either the Runtime or Development)
You might want to go with the Runtime first. The filesize is smaller.
- samir_bhansali
After installing the software. Got below message.
Every 1.0s: fpgainfo bmc
No FPGA resources found.
Attached snapshot.
