AFr12
New ContributorJoined 6 years ago
User Profile
New Contributor
User Widgets
Contributions
I2C Remote Upgrade Example for MAX10 (ug151) does not work
Hello! I wanted to evaluate the MAX10 Remote Upgrade over I2C (v17.1) with 10M50 and 10M08 Eval Boards, but I was not able to get the NIOS running and communicate over UART. I could download all .pof and .sof images as described, but the core never responded. I noticed that downloading the NIOS firmware into QSPI flash takes much less time than described in the user guide.I also disabled the VTAP, but it did not work either. Is there a special 10M50 Eval Board setup required? Thank you in advance!1.3KViews0likes4Comments