Forum Discussion

SATC's avatar
SATC
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

When I'm in the programming window and trying to pass the pof file to MAX I get the following error "Cannot add target device EPCQL1024 to device chain when in current programming mode" how should I proceed? What would be the other way to programming MAX?

I have a problem programming the MAX and cyclone 10 GX. In the programming window I can set the .sof file to pass to Cyclone, but when I select the MAX .pof file I get the following error: "Cannot ad...
Abe's avatar
Abe
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

When trying to program the Max device have you tried changing the Programming mode. If its in the JTAG mode, set it to Active Serial and then try.

  • SATC's avatar
    SATC
    Icon for Occasional Contributor rankOccasional Contributor
    6 years ago

    in the Active Serial mode the board is not detected