Thank you Aqid! The file was not everything I was looking for, but thank you for looking. However, I managed to get the FPGA on the board to program after some sleuthing around the Internet.
For everyone else and people reading this thread years later, I got the board to program in Quartus 25.1.1 with a .sof file generated via the bts_config example project included in the install package file (agilex_agib027r29a1e2vr3_fpga_nen_revb_v24.1b115_v1.0.zip) that I modified. The .qsf file supplied with the example project with the default settings will generate a .sof file that will not succeed to program. I made the following edits:
**** Step 1, change device ****
Change:
set_global_assignment -name DEVICE AGIB027R29A1E2VR3
to:
set_global_assignment -name DEVICE AGIB027R29B1E2VR2
set_global_assignment -name DEVICE_MIGRATION_LIST "AGIB027R29B1E2VR2,AGIB027R29B1E2V"
**** Step 2, reintroduce deprecated settings from old example projects ****
Delete the Power Management and VID settings and then follow instructions from section 3.5 (page 20) from old archived user guide to repopulate the old settings:
https://web.archive.org/web/20221222195748/https://cdrdv2-public.intel.com/677252/ug-agilex-i-fpga-devl-kit-683288-677252.pdf
The old user guide will instruct you to set PWRMGT_SLAVE_DEVICE_TYPE to ED8401, a deprecated chip.
**** Step 3 ****
Delete:
set_global_assignment -name BOARD "Intel Agilex 7 FPGA I-Series Development Kit 2xR-Tile and 1xF-Tile DK-DEV-AGI027RBES"
**** Step 4 ****
Make sure all switches on the board are set to the factory default setting as per the Dev Kit User Guide.
**** Step 5 ****
Program the device.
**** Trouble shooting ****
If you're getting an error like this:
Error(18948): Error message received from device: Bitstream error. (Subcode 0x0050, Info 0x00000003, Location 0x00000800)
Error(18948): Error message received from device: Detected a bitstream error during configuration.
Error(23925): Debug suggestion: Potential errors: Device selected in Intel Quartus Prime project mismatch with the target device.
you likely did Step 2 correctly, but Step 1 incorrectly
If you're getting an error like this:
Error(18948): Error message received from device: Internal error. (Subcode 0x001A, Info 0x00000000, Location 0x00004400)
Error(18948): Error message received from device: Detected an error during configuration.
you're likely did Step 1 and Step 2 correctly but ran into the issue described here:
https://community.intel.com/t5/Intel-Quartus-Prime-Software/Error-18948-Error-message-received-from-device-Internal-error/m-p/1390454/highlight/true
New Contributor
